MODULE I: BASIC ENGINEERING SKILLS
Use different type of tools used for carpentry, fitting,
drilling, and plumbing etc.
Perform soldering & brazing etc., Make sample sheet
metal articles.
Cut conduit pipe and make threading on it.
MODULE II: BASIC ELECTRICAL ENGINEERING
Wire & test simple electrical circuits, in different
types of wirings with suitable controlling
& protective devices, observing I-S Standards &
I.E rules.
Define & measure electrical quantities like voltage
current resistance power & energy
using appropriate & different instruments like voltmeters,
ammeters, multimeter , watt
meters, etc.
Test wiring installation for insulation resistance faults-using
appropriate instruments &
Rectify faults.
Test, charge & door outline maintenance of different
types of batteries.
Define Magnetism, Electromagnetism, and magnetic field etc.
Check a capacitor and identify the HT & LT winding of
transformer and able to find
output of transformer.
Testing of contactors & alarm circuits.
MODULE III: BASIC ELECTRONICS
Use the hand tools correctly & safely. Use wire gauge,
feeler gauge, read colour code of resisters etc., Capacitors,
verify ohms law, series, parallel connections etc., voltmeter,
ammeter, ohm meter & multimeter correctly, observing
safety precautions in handling them. Use of wheat-stone
bridge, lcr bridge to measure l c & r Solder wires on
PCB, using proper soldering iron of different wattages correctly.
Identify & test hf, af coils, wind small coils &
test them.
Read data book for semiconductors, connect them properly
in circuits, plot characteristics.
Use of oscilloscope, signal generator, transistor tester
etc. Trace circuit diagrams & interpret circuit diagrams.
MODULE IV: BASIC ELECTRICAL WIRING & WINDING
Understand different types of wiring, i.e. Rules, cable
joints, soldering, etc.
Testing and installation for motors.
Understand the procedure of batten wiring system, casing
capping wiring system, conduit pipe wiring system for domestic
& industrial, fault tracing in various wiring system.
Re-wind a transformer/simple motor of small size.
Understand different types of AC/ DC Windings of motors
& transformers.
MODULE V: BASIC POWER GENERAION, TRANSMISSION & DISTRIBUTION
Work on various sources of power generation.
Erect the transmission of different voltages. Find faults
in transmissions lines.
Install circuit breaker / switch gear.
Test and replace the safety measures of transforms.
Install and find faults in different types of distribution
systems.
Test relays in various protection schemes.
Test and maintain power & distribution transformer.
MODULE VI: BASIC COMPUTER OPERATING SKILL & ITS APPLICATION
Have operational skill of computer, To enter data, prepare
bills, prepare tool list etc.,
Download information from internet.
Draw electrical layouts, drawing, wiring diagrams, Simulate
simple electrical circuits
